HP Enterprise 500 manual Lifter drive assembly, Remove the lifter drive assembly

Lifter drive assembly

Before proceeding, remove the following components:

●Toner collection unit. See Toner collection unit on page 79.

●Formatter. See Formatter PCA on page 81.

●Right rear cover. See Right rear cover on page 109.

●Left cover. See Left cover on page 111.

●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.

NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the lifter drive assembly.

●Interconnect board (ICB). See Interconnect board (ICB) on page 158.

●Low voltage power supply. See Low voltage power supply on page 163.

●High voltage power supply lower. See High voltage power supply lower (HVPS-D) on page 167.

Remove the lifter drive assembly

1.Disconnect eight connectors (callout 1), and then release the wire harness from the retainers. Figure 2-147Remove the lifter drive assembly (1 of 2)

1

ENWW Internal assemblies 173