HP Enterprise 500 manual 189Reinstall the PGC actuators 5 Removal and replacement

4.Place the end of the actuator into the PGC rod, and then use a small flat blade screw driver to fasten the end of the spring on the tab on the chassis.

Figure 2-188Reinstall the PGC actuators (4 of 5)

5.Push down on the actuator to seat it into place. Verify that the actuators is correctly installed. The PGC actuator should freely move when you push in on the actuator.

Figure 2-189Reinstall the PGC actuators (5 of 5)

200 Chapter 2 Removal and replacement ENWW