HP Enterprise 500 manual Fuser Temp Normal Alternate

Table 3-21General Settings menu (continued)

First level	Second level	Third level	Fourth level	Values	Description
		Transfer Control		Normal*	Use this setting to
				Alternate 1	correct transfer issues
					in print jobs. Turn this
				Alternate 2	feature on if green,
					mottled images are
				Alternate 3	printed on the page.
					Note that using this
					mode can increase
					problems with blurry
					images or specks of
					toner on the leading
					or trailing edge of
					the paper. The
					default setting is
					Normal. The
					Alternate 1 setting
					reduces the T1 bias
					and should be used
					when re-transfer
					occurs. The
					Alternate 2 setting
					increases the inter-
					page gap. Using this
					setting reduces
					throughput and might
					decrease the print-
					cartridge life. The
					Alternate 3 setting
					applies the
					Alternate 1 and
					Alternate 2 settings
					at the same time. Use
					this setting if the first
					two settings do not
					correct the problem.

Fuser Temp	Normal*
	Alternate

If you are seeing a faint image of the page repeated at the bottom of the page or on the following page, you should first make sure the Paper Type and Print Mode settings are correct for the type of paper you are using. If you continue to see ghost images on your print jobs, set the Fuser Temp feature to the Alternate setting.

344 Chapter 3 Solve problems ENWW