Before proceeding, remove the following components:
●Toner collection unit. See Toner collection unit on page 79.
●Formatter PCA. See Formatter PCA on page 81.
●Right rear cover. See Right rear cover on page 109.
●Left cover. See Left cover on page 111.
●Hardware integration pocket (HIP). See Hardware integration pocket (HIP) (dn and xh models only) on page 115.
●Control panel assembly. See Control panel assembly on page 116
●Front top cover. See Front top cover on page 122.
●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove drum motor 1.
●Rear top cover. See Rear top cover on page 127.
●Interconnect board (ICB). See Interconnect board (ICB) on page 158.
●DC controller. See DC controller PCA and tray on page 160.
●Low voltage power supply. See Low voltage power supply on page 163.
●High voltage power supply upper. See High voltage power supply upper
206 Chapter 2 Removal and replacement | ENWW |