2.Use a small flat blade screwdriver to carefully remove four locking clips (callout 1).

CAUTION: Do not damage the PCA with the screwdriver.

Figure 2-140Remove the high voltage power supply lower (2 of 4)

1

3.Disconnect one connector (callout 1; J114), and then release four clips (callout 2).

NOTE: To locate DC controller connector locations, see DC controller PCA on page 284.

Figure 2-141Remove the high voltage power supply lower (3 of 4)

1

2

168 Chapter 2 Removal and replacement

ENWW