3.Slowly rotate the shaft near the black cam.

WARNING! Do not touch the plastic gears or cams. You must not wipe away any of the grease that is applied to these components. Always rotate the gears and cams by rotating the metal drive shaft.

Figure 2-208Reinstall the main drive assembly (3 of 11)

4.Continue to rotate the shaft until the holes in the black-cam gear align as shown below.

When correctly aligned, the bottom-mosthole in the gear is aligned with a hole in the sheet-metal chassis.

NOTE: The holes in the other cam gears have a different alignment. You must make sure that the holes in the black-cam gear are correctly aligned.

Figure 2-209Reinstall the main drive assembly (4 of 11)

218 Chapter 2 Removal and replacement

ENWW