HP Enterprise 500 manual 55Preboot menu options 5

Table 3-55Preboot menu options (5 of 5)

Menu option	First level	Second level Third level	Description
Administrator	Startup		Select the Startup Options item to specify options that can
continued	Options		be set for the next time the product is turned on and initializes
			to the to Ready state.
		Cold Reset	Check the Cold Reset item to clear the IP address and all
			customer settings (this item also returns all settings to factory
			defaults).
			NOTE: Items in the Service menu are not reset.
		First Power	Not currently functional: This item allows the product initialize
			as if it is the first time it has been turned on.
			For example, the user is prompted to configure first time
			settings like Select Date/Time, Select Language, and other
			settings.
			Check this item so that it is enabled for the next time the
			product power is turned on.
			When the product power is turned on the next time, this item
			is unchecked so that the pre-configured settings are used
			during configuration and the first time setting prompt is not
			used.
		Skip Plug-ins	This item allows the device to be started without loading the
			third party applications.
			This means that files including Accessible Architecture on the
			disk will not be available at bootup. This is useful for
			troubleshooting problems with the hard disk without having to
			remove the hard disk. It also applies to flash file system disks
			on DIMMs.
			In this case, this function will cause the printer to configure the
			HP firmware first, followed by the third-party applications.
			NOTE: The files on the disk will be available after the
			printer enters the Ready state.
		Skip Cal	Select the Skip Cal item to initialize the product the next time
			the power is turned on without calibrating.
		Show	Not currently functional: Check the Show Revision item to
		Revision	allow the product to initialize and show the firmware version
			when the device reaches the Ready state.
			Once the product power is turned on the next time, the Show
			Revision item is unchecked so the firmware revision is not
			shown.
		Lock Service	CAUTION: Select the Lock Service item to lock the
			Service menu access (both PreBoot and Device Maintenance
			application).
			Service personnel must have the Administrator remove the
			Lock Service setting before they can enter the Service
			menu.

ENWW Preboot menu options 519