Intel 80C188XL, 80C186XL user manual Typical Ct = V 1 e, 1µf typical

CLOCK GENERATION AND POWER MANAGEMENT

Reset may be either cold (power-up) or warm. Figure 5-6 illustrates a cold reset. Assert the RES input during power supply and oscillator startup. The processor’s pins assume their reset pin states a maximum of 28 X1 periods after X1 and VCC stabilize. Assert RES 4 additional X1 peri- ods after the device pins assume their reset states.

Applying RES when the device is running constitutes a warm reset (see Figure 5-7). In this case, assert RES for at least 4 CLKOUT periods. The device pins will assume their reset states on the second falling edge of X1 following the assertion of RES.

	Vcc
	-t
	RC
50 k typical	Vc(t) = V 1 - e

RESET IN

1µf typical

RES

A1521-0A

Figure 5-5. Simple RC Circuit for Powerup Reset

The processor exits reset identically in both cases. The falling RES edge generates an internal RE- SYNC pulse (see Figure 5-8), resynchronizing the divide-by-two internal phase clock. The clock generator samples RES on the falling X1 edge. If RES is sampled high while CLKOUT is high, the processor forces CLKOUT low for the next two X1 cycles. The clock essentially “skips a beat” to synchronize the internal phases. If RES is sampled high while CLKOUT is low, CLK- OUT is already in phase.

5-7