LaserSpeed 8000-3 Instruction Handbook
LaserTrak Software
can be accomplished by making the speed go to zero thereby freezing the length counter or by using the Material present signal to freeze length readings. The length must remain the same for a minimum of 80 ms. In the Successive Reading mode the software is continually reading the length, speed and Quality factor from the gauge every User Update period.
Final Length mode uses the TF command in the gauge. The TF command sets the gauge to output only the final length and average Quality Factor at the end of each part being measured. The gauge only outputs one data point per length measurement. The Material present signal determines when the length measurement starts and stops. The minimum time that Material Present can be off is 4 ms for the gauge to act on the Material present signal and output the final length and Quality factor.
The bin size of the histogram is determined by the Hist. Minimum, Hist. Maximum settings and #Data Bins shown in Length Statistics. The bin size lumps all length measurements within a bin size into one bin and considers them at one length. This can be set to minimum of 0.001. The Hist. Minimum and Hist Maximum set the upper and lower limit of lengths that will be used in the histogram. Lengths outside these values will be shown on the table on right side of the screen but not used in the histogram. In addition a Red number will appear in the upper right and left corner of the graph to indicate how many length readings are larger then the Hist. Maximum and smaller then the Hist. Minimum.
The length readings are also displayed in a tabular format on the right hand side of the display.
Length statistics are shown at the bottom of the screen.
Ignore if Below: allows the user to reject measurements below this threshold
Ignore if Above: allows the user to reject measurements above this threshold
Part No. 93463 / Drawing No. | Page 119 of 221 | Revision A (Sep 2007) |
