LaserSpeed 8000-3 Instruction Handbook

Installing the System

Twinner Lines

When mounting the gauge on a twinner line, the gauge should be positioned far enough from the twinner that the twist is set. If the gauge is placed close to the twinner, it may not be able to measure due to excessive vibration and the spin imparted on the wire due to the twisting motion. Moving the gauge down the line farther from the twinner may improve the gauge's ability to make measurements.

Near Twinner

Near Takeup

Wires spin and

Twist is set, wires not

corkscrew (make it

spinning or corkscrewing.

look like wires are

 

 

 

not moving)

 

 

 

 

 

 

 

Line Movement

Part No. 93463 / Drawing No. 0921-01561

Page 20 of 221

Revision A (Sep 2007)

Page 20
Image 20
Laser LS8000-3 manual Twinner Lines, Near Twinner Near Takeup