Laser LS8000-3 manual European Commission Requirements

LaserSpeed 8000-3 Instruction Handbook

European Commission Requirements

European Commission Requirements

This equipment is intended for use in a heavy industrial environment. The equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to other equipment. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to other equipment the user is encouraged to try to correct the interference by one or more of the following measures:

-Re-orientate or relocate the equipment.

-Increase the separation between the pieces of equipment.

-Connect the pieces of equipment on separate mains circuits.

-Ensure that the relevant items of equipment are properly and securely earthed to a common earth point using adequately sized cable or other means of connection.

Where supplied or specified, shielded interconnection cables must be employed with this equipment to ensure compliance with the pertinent RF limits. Changes or modifications not expressly approved by the company could void the user’s authority to operate the equipment.

This product has been rigorously tested to comply with the European EMC (Electromagnetic Compatibility) Directive. With regard to this, Beta LaserMike recommends that any non-Beta LaserMike peripheral equipment is CE marked for the Heavy Industrial environment (EN50082-2). Beta LaserMike also recommends that any cables not supplied by Beta LaserMike, but used for powering Beta LaserMike equipment, be built using good EMC practices (i.e. cables with braided shield, and connectors with 360° termination of the braid to a metal/metalised shell connector at both ends). If you have any questions regarding this, contact the Beta LaserMike Service Department.

Part No. 93463 / Drawing No. 0921-01561 Page 8 of 221 Revision A (Sep 2007)