
|
|
| LaserSpeed |
|
|
| |
|
|
| User Scaleable Pulse Rate |
P |
|
| |
P<CR> | Read | ||
| Response Format: <N> | ||
P<N><CR> | Set | ||
| <N> is an integer from 0 to 999,999,999 that is the number of pulses per unit length scaled | ||
| by 1000. | ||
| The User Scaleable Pulse Output can output pulses at rates higher than 250kHz. Caution | ||
| should be used to ensure that the maximum line speed encountered during operation does | ||
| not cause the pulse output frequency to exceed the maximum frequency of the counter. | ||
| Many counters have surprisingly low maximum frequency specifications. If the pulse | ||
| frequency exceeds the counter maximum frequency, the counter may behave erratically. | ||
| Example: | ||
| Want 100 pulses/inch | ||
| Measurement Units are inches/minute | ||
| Pulses/Length = 100 x 1000 = 100000 | ||
| Command to set the value is: P100000<CR> | ||
| Note: Changing this setting will cause a reset, will reset the indicated length, and will cause | ||
| the pulse outputs to be momentarily interrupted. Do not change this setting during normal | ||
| operation. | ||
|
|
| Read Firmware Version |
Z |
|
| |
Z<CR> | Read Only Command | ||
| Response Format: LS8KV*<CR> | ||
| Where * is a capital letter indicating the firmware version. |
Part No. 93463 / Drawing No. | Page 147 of 221 | Revision A (Sep 2007) |