
LaserSpeed 8000-3 Instruction Handbook
The output will clear when the length reaches 200ft, and the Index Pulse triggers. See the Index Pulse & Length Thresholds section for timing details.
$H | High Speed Pulse Output Configuration |
$H<CR> Read
Response Format: <N>
$H<N><CR> Set
<N> is an integer that specifies the function of the High Speed Pulse Output. The various outputs were described previously in the Index Pulse Output Function description.
| Value |
| Pulse Output Function | |
|
| Phase A | Phase B | |
|
|
| ||
0 |
| Default (High Speed Pulse Outputs) | ||
|
|
|
| |
1 |
| System Ready | Material Present | |
|
|
|
| |
2 |
| System Ready | Valid | |
|
|
|
| |
3 |
| System Ready | QF Pulse Output | |
|
|
|
| |
4 |
| System Ready | QF Warning Output | |
|
|
|
| |
5 |
| System Ready | Shutter Open | |
|
|
|
| |
6 |
| System Ready | Laser On | |
|
|
|
| |
7 |
| System Ready | Thermostat Output | |
|
|
|
| |
8 |
| Valid | Thermostat Output | |
|
|
|
| |
9 |
| Pulse Phase A | Sync Output | |
|
|
|
|
|
Note: Some of the above outputs were previously described under the Index Pulse Output Function setting.
Sync Output
L | High Speed Pulse Rate |
L<CR> Read
Response Format: <N>
L<N><CR> Set
Part No. 93463 / Drawing No. | Page 144 of 221 | Revision A (Sep 2007) |