
LaserSpeed 8000-3 Instruction Handbook
*DHCP | DHCP Enable/Disable |
*DHCP?<CR> Read
Response Format: *DHCP=<N><CR>
*DHCP=<N><CR> Set
<N> is an integer, either 0 or 1. This controls whether or not the gauge attempts to connect to a DHCP (Dynamic Host Configuration Protocol) server and receive a network address automatically. If you are connecting directly to a PC with a crossover cable, this option should be disabled.
If this setting is changed, the new value will take effect after a power cycle.
Value | Effect | IP Address |
| DHCP Disabled |
|
| The | Read from |
0 | obtain an address from a DHCP server. The IP | |
| Address, Netmask, and Default Gateway will be | Memory |
| read from |
|
|
|
|
| DHCP Enabled |
|
| The |
|
1 | an address from the DHCP server. The IP | Automatic |
| Address, Netmask, and Default Gateway will be |
|
| read from the server, and the settings stored in |
|
|
| |
|
|
|
If you are unsure as to whether or not you have a DHCP server on your network, contact your system administrator.
This setting can be disregarded if the Ethernet option is not installed. Note: This setting will take effect after a
Part No. 93463 / Drawing No. | Page 151 of 221 | Revision A (Sep 2007) |