Laser LS8000-3 manual UDP Power-On Data Destination IP Address, UDP Power-On Data Destination Port

LaserSpeed 8000-3 Instruction Handbook

RS-232/RS-422 Communication

*AUTOADDR UDP Power-On Data Destination IP Address

*AUTOADDR?<CR>

Read

Response Format: *AUTOADDR=<N><CR>

Set

*AUTOADDR=<XXX.XXX.XXX.XXX><CR>

Where <XXX.XXX.XXX.XXX> is an IP Address, such as "192.168.10.246". This command configures the destination IP address for UDP output data. If the gauge is not configured to output UDP data on start-up, then this setting is not used.

*AUTOPORT UDP Power-On Data Destination Port

*AUTOPORT?<CR>

Read

Response Format: *AUTOPORT=<N><CR>

Set

*AUTOPORT=<N><CR>

Where <N> is an IP port number, such as 1234. This command configures the destination Port for UDP output data. If the gauge is not configured to output UDP data on start-up, then this setting is not used. This port should be set to a value higher than 1024 so that it doesn't interfere with standard network interfaces.

Part No. 93463 / Drawing No. 0921-01561 Page 163 of 221 Revision A (Sep 2007)