Connecting your camcorder to your computer using the USB cable

6Turn the POWER switch to OFF (CHG) on your camcorder, and then disconnect the USB cable.

7Restart your computer.

Step 2: Install the USB driver on the supplied

CD-ROM

Perform the entire procedure described in “Installing the USB driver” on page 234.

Raccordement de votre caméscope à votre ordinateur à l’aide du câble USB

6Réglez le commutateur POWER sur OFF (CHG) sur votre caméscope, puis débranchez le câble USB.

7Redémarrez l’ordinateur.

Etape 2 : Installez le pilote USB à partir du CD-ROM fourni

Effectuez toute la procédure décrite dans la section “Installation du pilote USB” à la page 234.

Viewing images recorded on a “Memory Stick”

Step 1: Uninstall the incorrect USB driver

1Turn on your computer and allow Windows

to load.

2Insert a “Memory Stick” into your camcorder.

3 Connect the AC Adaptor, and set the POWER

switch to MEMORY.

4 Connect the (USB) jack on your camcorder to the USB connector on your computer using the supplied USB cable.

5Open your computer’s “Device Manager.”

Windows XP:

Select “Start” t “Control Panel” t “System” t “Hardware” tab and click the “Device Manager” button.

If there is no “System” inside “Pick a category” after clicking “Control Panel,” click “Switch to classic view” instead.

Windows 2000:

Select “My Computer” t “Control Panel” t “System” t “Hardware” tab, and click the “Device Manager” button.

Other OS:

Select “My Computer” t “Control Panel” t “System,” and click “Device Manager.”

Visionnage d’images enregistrées sur un “Memory Stick”

Etape 1 : Désinstallez le pilote USB incorrect

1Mettez l’ordinateur sous tension et laissez

Windows se charger.

2Insérez un “Memory Stick” dans votre caméscope.

3Branchez l’adaptateur secteur, puis réglez le commutateur POWER sur MEMORY.

4 Raccordez la prise (USB) de votre caméscope au connecteur USB de votre ordinateur à l’aide du câble USB fourni.

5Ouvrez le “Gestionnaire de périphériques” de votre ordinateur.

Windows XP :

Sélectionnez “Démarrer” t “Panneau de configuration” t “Système” t et l’onglet “Matériel”, puis cliquez sur le bouton “Gestionnaire de périphériques”.

Si vous ne trouvez pas “Système” dans “Choisissez une catégorie” après avoir cliqué sur “Panneau de configuration”, cliquez sur “Basculer vers l’affichage classique” à la place.

Windows 2000 :

Sélectionnez “Poste de travail” t “Panneau de configuration” t “Système” t l’onglet “Matériel”, puis cliquez sur le bouton “Gestionnaire de périphériques”.

Autres systèmes d’exploitation :

Sélectionnez “Poste de travail” t “Panneau de configuration” t “Système” t puis cliquez sur “Gestionnaire de périphériques”.

242