Sunfire B1600 manual Address Table Settings, Displaying the Address Table

MIB Variables Associated With Mapping DSCP to CoS Values

TABLE 0-1MIB Variables Associated With Mapping DSCP to COS Values

Field Name	MIB Variable	Access	Value Range	Default Value
IP DSCP Value	sun...	Not-	Integer (0-63)
	priorityMgt.	accessible
	prioIpDscpTable.
	prioIpDscpEntry.
	prioIpDscpValue
IP DSCP CoS	sun...	Read/write	Integer (0-7)	page 3-90
	priorityMgt.
	prioIpDscpTable.
	prioIpDscpEntry.
	prioIpDscpCos

3.3.6Address Table Settings

Switches store the addresses for all known devices. This information is used to route traffic directly between the inbound and outbound ports. All the addresses learned by monitoring traffic are stored in the dynamic address table. You can also manually configure static addresses that are bound to a specific port.

3.3.6.1Displaying the Address Table

The Address Table contains the MAC addresses dynamically learned by monitoring the source address for traffic entering the switch. When the destination address for inbound traffic is found in the database, the packets intended for that address are forwarded directly to the associated port. Otherwise, the traffic is flooded to all ports. The Address Table also includes static MAC addresses that are tied to a specific port. (See “Configuring Static Addresses” on page 3-121.)

When viewing the Address Table through the web interface or CLI, the following parameters are displayed:

■Port ID (Interface17) – The port or aggregated link. Up-link ports NETP0 to NETP7 or down-link ports SNP0 to SNP15. You cannot display the MAC address table for NETMGT.

■VLAN ID – The VLAN identifier (between 1 and 4094). (This field includes the VLAN ID and name.)

■MAC Address – The MAC address associated with this interface.

17.CLI displays Interface.

3-92Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003