TABLE B-3Command Line Error Messages (Continued)

Message

Description

 

 

This command for console

Line mode (vty) can not use console parameter

only.

commands.

This command is only valid Only one port can be added to an aggregated link for adding a single port to a with this command.

an aggregated link.

This command is only valid for the name of a single port.

When setting the port description, multi-port selection is not accepted.

This command is not supported for management port in current release.

The “no switchport allow vlan” command cannot be used for the management port.

Trunk ID: trunk is out of

Trunk id is not allowed.

range.

 

Trunk trunk does not exist.

Trunk trunk is a normal trunk.

Trunk with no members cannot be displayed.

This trunk does not exist.

This trunk is a normal trunk.

Trunk member cannot be configured or displayed.

Type "show ?" for a list of

You only input the “show” command.

subcommands.

 

Unknown error.

Unknown error.

Unrecognized command.

Unrecognized command.

 

 

1 Indicates the value specified for a command.

B-8Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003

Page 380
Image 380
Sunfire B1600 manual Line mode vty can not use console parameter