Syntax

capabilities {1000full 100full 100half 10full 10half flowcontrol symmetric}

no port-capabilities [1000full 100full 100half 10full 10half flowcontrol symmetric]

1000full – Supports 1000 Mbit/sec full-duplex operation

100full – Supports 100 Mbit/sec full-duplex operation

100half – Supports 100 Mbit/sec half-duplex operation

10full – Supports 10 Mbit/sec full-duplex operation

10half – Supports 10 Mbit/sec half-duplex operation

flowcontrol – Supports flow control

symmetric (Gigabit only) – When specified, the port transmits and receives pause frames; when not specified, the port will auto-negotiate to determine the sender and receiver for asymmetric pause frames. (The current switch ASIC only supports symmetric pause frames.)

Default Setting

NETMGT: 10half, 10full, 100half, 100full

NETP0-7:10half, 10full, 100half, 100full, 1000full, flowcontrol

SNP0-15: 1000full

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

SNP0-15 down-link port capabilities are fixed at 1000full.

NETP0-7 up-link port capabilities include 10half, 10full, 100half,

100full, 1000full, flowcontrol and symmetric. When auto-negotiation is enabled with the negotiation command, the switch negotiates the best settings for a link based on the capabilites command. When auto- negotiation is disabled, you must manually specify the link attributes with the speed-duplexand flowcontrol commands.

NETMGT port capabilities are fixed at 10half, 10full, 100half, 100full.

4-88Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003

Page 286
Image 286
Sunfire B1600 manual SNP0-15 1000full