Sunfire B1600 manual System Errors, Command Line Errors, Table B-2System Error Messages

B.5.2 System Errors

The key error messages generated by the switch are listed in the following table. To control the message levels issued by the switch, see “logging history” on page 4-35.

TABLE B-2System Error Messages

Message Description Level3

module1 create task fail.

module task idle too long.

Specified software module cannot create the task.	2
Specified software module stayed in idle state too	2
long.

Allocate string2 memory fail.	Allocate memory failed for specified String.	2
Free string memory fail.	Free memory failed for specified String.	2
string switch to default.	Specified value is invalid or not supported; the default	3
	value will be used. (Please refer to the on-line help or
	this manual for information on acceptable values.)

1Indicates the switch software module (for example, STA, VLAN, XFER, TRAP, or RMON).

2Indicates the value specified for a configuration setting.

3The syslog message level. (See “logging history” on page 4-35.)

B.5.3 Command Line Errors

The error messages generated by the switch for the command-line interface are listed in the following table. Note that these messages are not written to the log file.

TABLE B-3Command Line Error Messages

Message		Description
Ambiguous command: string1		Ambiguous command.
Clear	dynamic address error.	Cannot clear dynamic address.
CLI internal error - contact		CLI command internal error.
your	local service provider.
Copy	error.	Copy failed.
Exec-timeout could not be		Telnet session cannot disable exec-timeout.
disabled for vty session.
Factory default configuration		Factory default file cannot be deleted.
file	cannot be deleted.
Factory default configuration		Factory configuration file cannot be replaced.
file	cannot be replaced.
Failed to allocate resource.		Not enough resources.

B-6Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003