Sunfire B1600 manual Link Aggregation Commands

Command Mode

Privileged Exec

Command Usage

This command displays the currently configured source port, destination port, and mirror mode (RX, TX, RX/TX).

Example

The following shows mirroring configured from port SNP6 to port NETP2:

Console(config)#interface ethernet NETP2 Console(config-if)#port monitor ethernet SNP6 Console(config-if)#end

Console#show port monitor Port Mirroring

-------------------------------------

Destination port(listen port):NETP2

Source port(monitored port)	:SNP6
Mode	:RX/TX
Console#

Related Commands

port monitor (4-164)

4.3.17Link Aggregation Commands

Ports can be statically grouped into an aggregated link to increase the bandwidth of a network connection or to ensure fault recovery. Or you can use the Link Aggregation Control Protocol (LACP) to negotiate a dynamic aggregated link between this switch and another network device. For static aggregated links, the switches connected to must be of the same type. But for dynamic aggregated links, the switches simply have to comply with LACP. This switch supports up to six

4-166Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003