4-134 Sun Fire B1600 Blade System Chassis Switch Administration Guide •June 2003
Default Setting
■join: 20 centiseconds
■leave: 60 centiseconds
■leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
■Group Address Registration Protocol (GARP) is used by GVRP and GMRP to
register or deregister client attributes for client services within a bridged LAN.
The default values for the GARP timers are independent of the media access
method or data rate. These values should not be changed unless you are
experiencing difficulties with GMRP or GVRP registration/deregistration.
■Timer values are applied to GVRP for all the ports on all VLANs.
■Timer values must meet the following restrictions:
leave >= (2 x join)
leaveall > leave
Note – Set GVRP timers on all Layer 2 devices connected in the same network to the
same values. Otherwise, GVRP will not operate successfully.
Example
Related Commands
show garp timer (4-135)
Console(config)#interface ethernet SNP1
Console(config-if)#garp timer join 100
Console(config-if)#