Sunfire B1600 manual Command-line Interface Configuring Static Addresses

3.4.5.2Command-line Interface: Configuring Static Addresses

This example adds the same items to the static address table:

Console(config)#interface ethernet NETP4 Console(config-if)#port security Console(config-if)exitConsole(config)#mac-address-table static 00-80-c8-00-00-01

interface ethernet NETP4 vlan 1 permanent Console(config)#mac-address-table static 00-80-c8-00-00-02

interface ethernet NETP4 vlan 1 delete-on-reset

Console(config)#exit

Console#show mac-address-table ethernet NETP4

Interface	Mac Address	Vlan	Type
-----------	-----------------	----	-----------------
NETP4	00-80-C8-00-00-01	1	Permanent
NETP4	00-80-C8-00-00-02	1	Delete-on-reset
Console#

3.4.5.3MIB Variables Associated With Static Addresses

TABLE 3-37MIB Variables Associated With Static Addresses

				Default
Field Name	MIB Variable	Access	Value Range	Value
Static Receive	MIB-II.	Read/write	Integer
Port	dot1dBridge.
	dot1dStatic.
	dot1dStaticTable.
	dot1dStaticEntry.
	dot1dStaticReceiv
	ePort
Port Security	sun...	Read/write	enabled (1),	disabled
Status	securityMgt.		disabled (2)
	portSecurityMgt
	portSecPortTable.
	portSecPortEntry.
	portSecPortStatus
Number of	Not Defined
Static
Addresses

Chapter 3 General Management of the Switch 3-123