HP 8753E manual Running a Sequence, Stopping a Sequence

3.To create a test sequence, enter the parameters for the measurement that you wish to make. For this example, a SAW filter measurement is set up with the following parameters:

The above keystrokes will create a displayed list as shown:

Start of Sequence

RECALLPRSTSTATE ~UIS: PMD s21 (R/R)

LOG MAG

CENTER

134M/u

SPAN

50 M/u

SCALE/DIV AUTO SCALE

4.To complete the sequence creation, press:

Caution	When you create a sequence, the analyzer stores it in volatile memory where
	it will be lost if you switch off the instrument power (except for sequence #6
	which is stored in the analyzer non-volatile memory). However, you may store
	sequences to a floppy disk.

Running a Sequence

To run a stored test sequence, press:

Preset] and the softkey labeled with desired sequence number or, press:

,, i_ _ ..~...

m ~~~~~~~, md the softiey labeled ti* the desired sequence nmber*

Stopping a Sequence

To stop a sequence before it has finished, pressm.

2.70 Making Measurements