softkey labels, l-10 softkeys, 14

stimulus function block, l-4 test sequence connector, 1-12 test set interconnect, 1-12

logarithmic frequency sweep, 6-23 log magnitude format, 6-32

LOG MKR, 2-25, 2-26

loop counter sequence, 2-77

loss of power meter calibration data, 5-34 Lo to RF isolation for mixers, 3-33

low pass mode

reflection measurements, 6-131 setting frequency range, 6-130 transmission measurements, 6-133

M

magnitude specifications, 7-13

magnitude and insertion phase response measurement, 2-37

making accurate measurements electrically long devices, 548

making measurements, 2-l man status notation, l-9 marker

control, 2-18

values area on display, l-10 (&iZZZT] menu map, 818

emenu map, 8-8 markers

activating, 2-18

active and inactive, 2-18 calculate data statistics, 2-36 continuous and discrete, 2-17

couple and uncouple display markers, 2-24 coupled, 6-9

delta mode, 6-55 delta (A), 2-20 fixed, 2-21

fixed reference, 6-55 functions, 6-56 functions on display, 2-17 G+jB MKR, 2-26

LIN MKR, 2-25, 2-26 LOG MKR, 2-25, 2-26 menu, 6-55

modes, 6-56

moving off of grids, 2-19 polar format, 2-24, 6-56 reference, 2-20

Re/Im MRR, 2-25, 2-26 relative mode, 2-20 R+jX MKR, 2-26

search for bandwidth, 2-35

search for maximum amplitude, 2-32 search for minimum amplitude, 2-33 search for target amplitude, 2-34 searching, 2-32

search mode, 6-56

set CW frequency, 2-31 set display reference, 2-30 set electrical delay, 2-31 set frequency span, 2-29

set measurement parameters, 2-26 setting center frequency, 2-28 setting start frequency, 2-27 setting stop frequency, 2-27 smith chart, 6-56

Smith chart markers, 2-25 Smith or polar format, 2-22 target mode, 6-56 tracking amplitude, 2-35 using, 6-54-56

zero, 2-23 marker stats

bandwidth on display, l-10 masking

time domain, 6-135 mass storage, 11-5 matched adapters

using to calibrate noninsertable devices, 5-47, 6-109

math with data traces, 2-8 maximum amplitude search, 2-32 LMeas] key, 6-29, 6-30

LMeas) menu map, 8-9 measure

deviation from linear phase, 242 device under test, 2-5

electrical length and phase distortion, 2-40 gain and reverse isolation, 2-59

gain compression, 2-55 group delay, 2-43 increased accuracy, 5-2

magnitude and insertion phase response, 2-37

swept harmonics, 2-81

transmission response in time domain, 2-83

using Iimit lines, 2-46 using swept list mode, 2-61 using the time domain, 2-83

measured inputs of display, l-9 measurement

channel viewing, 2-6 conversion loss example, 3-11 data pointxsetting, 2-4

data statistics, 2-36 error-correction, 5-4

Index-13

Page 686
Image 686
HP 8753E manual Softkey labels, l-10 softkeys, LOG MKR, 2-25 Loop counter sequence, Low pass mode, Modes