HP 8753E manual Mo&fication.\ ~~~~~~~~lt~\brings up the printer color

selects channel 4 memory trace for display color modification.

selects channel 4 memory trace for display color 1 .z “i..m:; ;w;j:.,.,.,., _ ;~.....

mo&fication.\ ~~~~~~~~:lt~\brings up the printer color

..:..:..i.::: ....................i..~ ~~~.~~~... ...............................

selection menu. The channel 2 data trace default color is blue for color prints.

is used to apply the same power levels to each channel.

is used to apply different power levels to each channel.

configures multiple-channel displays so that the auxiliary channels are adjacent to or beneath the primary channels.

measures A and B inputs simultaneously for faster measurements.

when the parallel port is configured for GPIO, 8 output bits can be controlled with this key. When this key is pressed, “TTL OUT BIT NUMBER” becomes the active function. This active function must be entered through the keypad number keys, followed by the Lxl] key. The bit is cleared when the Ixl) key is pressed. Entering numbers larger than 7 will result in bit 7 being cleared, and entering numbers lower than 0 will result in bit 0 being cleared.

deletes ail segments in the list.

clears a sequence from memory. The titles of cleared sequences will remain in load, store, and purge menus. This is done as a convenience for those who often reuse the same titles,

dehnes the standard (and the offset) as coaxial. This causes the analyzer to assume linear phase response in any offsets.

applies a linear phase compensation to the trace for use with electrical delay. That is, the effect is the same as if a corresponding length of perfect vacuum dielectric coaxial transmission line was added to the reference signal path.

provides access to the configure menu. This menu contains softkeys used to control raw offsets, spur avoidance, and the test set transfer switch.

adjusts the degree of whiteness of the color being modified. See “Adjusting Color” for an explanation of using this softkey for color modification of display attributes.

provides access to the configure ext disk menu. This menu contains softkeys used to the disk address, unit number, and volume number.

located under the [s) key, selects the configure menu.

resumes a paused sequence.

Key Definitions 9-9