Modifying a Command

1.To enter the creation/editing mode, press:

2.To select the particular test sequence you wish to modify, (sequence 1 in this example), press:

~~~~~.:~~~~:~~~~~

. . . . . . .i. i i . . . . ..A. .v.:.w

The following list is the commands entered in “Creating a Sequence.’ Notice that for longer sequences, only a portion of the list can appear on the screen at one time.

Start of Sequence

RECALLPRSTSTATE Trans: FWD S21 (B/R)

LOG MAG

CENTER

134M/u

SPAN

50 M/u

SCALE/DIV AUTO SCALE

3.To change a command (for example, the span value from 50 MHz to 75 MHz), move the cursor (-+) next to the command that you wish to modify, press:

nIf you use the &) key to move the cursor through the list of commands, the commands are actually performed when the cursor points to them. This feature allows the sequence to be tested one command at a time.

nIf you wish to scroll through the sequence without executing each line as you do so, you can press the @J key and scroll through the command list backwards.

4.lb delete the current command (for example, span value), press:

El

5.To insert a new value (for example, 75 MHz), press:

_ _.,. / .,. . . . .

6. fiess m ~~~~~~~~~~~~~~ to etit the mo&fy (e&t) mode.

...._

,.:::...~~~.;;~~

....A..s.: ....A

.......A..7:,..: ::._... .:...a

w>

A.....;u;;:.;;;;Av~~~~:

Clearing a Sequence from Memory

1.To enter the menu where you can clear a sequence from memory, press:

2.To clear a sequence, press the softkey of the particular sequence.

2.72 Making Measurements

Page 123
Image 123
HP 8753E manual Modifying a Command, Clearing a Sequence from Memory