..,-

::::::::I::!!:~:::,::~~:!:~,;.;.,.,,., .....................................~

~

,.......:

~~~~~~~

changes the response value of the fixed marker. In a Cartesian format this is the y-axis value. In a polar or Smith chart format with a magnitude/phase marker, a real/imaginary marker, an

R + jX marker, or a G + jB marker, this applies to the first part of the complex data pair Fixed marker response values are always uncoupled in the two channels.

To read absolute active marker response values following a

. . .....~..<z<:)” ,, ;, .....

~~~~ operation, the response v&e c- be reset &J zero.

.‘..............~...~....-i .“. > ..: :::::.

defines a flat limit line segment whose value is constant with frequency or other stimulus value. This line is continuous to the next stimulus value, but is not joined to a segment with a different limit value. If a flat line segment is the final segment it terminates at the stop stimulus. A flat line segment is indicated as FL on the table of limits.

puts a form feed command into the display title.

presents a menu used to select the display format for the data. Various rectangular and polar formats are available for display of magnitude, phase, impedance, group delay, real data, and SWR.

specifies whether or not to store the formatted data on disk with the instrument state.

brings up a menu for formatting a disk.

causes subsequent disk initialization to use the DOS disk format.

causes subsequent disk initialixation to use the LIF disk format.

.. ___ _;__

~~~~:~~~~~ is the d&a&, setting.

..-...-............... ...-.........../ ,.,.,, &<<<<<. ,.

initializes media in external drive, and formats the disk using the selected (DOS or LIF) format.

initializes media in internal drive, and formats the disk using the selected (DOS or LIF) format.

clears all internal save registers and associated cal data and memory traces.

leads to the frequency offset menu.

switches the frequency offset mode on and off.

specifies the frequency of a calibration factor or loss value in the power meter cal loss/sensor lists

blanks the displayed frequency notation for security purposes. Frequency labels cannot be restored except by instrument preset or turning the power off and then on.

sets the LO frequency to CW mode for frequency offset.

8-16 Ksy Definltionr

Page 505
Image 505
HP 8753E manual ~~~~~~~