HP 8753E manual Gggs&fi

...................... ....

................. : ...

gggs&fi

i...................................... .:..... I.. .. .:.<

-.

g{~$;~~f

~~~~

.._...........

lets you enter a label for the reverse transmission class. The label appears during a calibration that uses this class.

specifies which standards are in the reverse transmission class in the calibration kit.

is used to enter the standard numbers for the reverse transmission (thru) calibration. (For default kits, this is the alru.)

adjusts the source frequency higher than the LO by the amount of the LO (within the limits of the analyzer).

adjusts the source frequency lower than the LO by the amount of the LO (within the limits of the analyzer).

draws a quarter-page plot in the lower right quadrant of the Page.

draws a quarter-page plot in the upper right quadrant of the page.

resets the seconds counter to zero in real-time clock.

presents the S-parameter menu, which is used to define the input ports and test set direction for S-parameter measurements

provides a measurement calibration for reflection-only measurements of one-port devices or properly terminated two-port devices, at port 1 of an S-parameter test set or the test port of a transmission/reflection test set.

is used to enter the standard numbers for the Rrst class required for an SII l-port calibration. (For default cal kits, this is the open.)

is used to enter the standard numbers for the second class required for an S11 l-port calibration. (For default cal kits, this is the short.)

is used to enter the standard numbers for the third class required for an SKI l-port calibration. (For default kits, this is the load.)

measures the short circuit TRLLRM calibration data for PORT 1.

provides a measurement calibration for reflection-only measurements of one-port devices or properly terminated two-port devices, at port 2 of an S-parameter test set or the test port of a transmission/reflection test set.

is used to enter the standard numbers for the hrst class required for an SZ2 l-port calibration. (For default cal kits, this is the open.)

is used to enter the standard numbers for the second class required for an f&z. l-port calibration. (For default cal kits, this is the short.)

Key Definitions 8-39