HP 8753E Couples the marker stimulus values for the two display, Stimulus settings, Standard

	couples the marker stimulus values for the two display
	channels. Even if the stimulus is uncoupled and two sets of
	stimulus values are shown, the markers track the same stimulus
	values on each channel as long as they are within the displayed
	stimulus	range.
	places markers only on measured trace points determined by
	the stimulus settings.
	allows the marker stimulus values to be controlled
	independently on each channel.
	moves the active marker to the maximum point on the trace.
	is used to define the highest frequency at which a calibration
	kit standard can be used during measurement calibration. In
	waveguide, this is normally the upper cutoff frequency of the
	standard.
	key provides access to a series of softkey menus for selecting
	the parameters or inputs to be measured.
ffJiiks= ltlixr#T	aborts the sweep in progress, then restarts the measurement.
	This can be used to update a measurement following an
	adjustment of the device under test. When a full two-port
	calibration is in use, the l4K&%M .&BT&TO key will initiate
				.
	another update of both forward and reverse S-parameter data.
	This softkey will also override the test set hold mode, which
	inhibits continuous switching of either the test port transfer
	switch or step attenuator. The measurement configurations
	which cause this are described in Test Set Attenuator, Test
	Port Transfer Switch, and Doubler Switch Protection, at the
	beginning of this section. This softkey will override the test set
	hold mode for one measurement.
	If the analyzer is taking a number of groups (see Trigger
	l&mu), the sweep counter is reset at 1. If averaging is on,
		... .=		resets the sweep-to-sweep averaging and is
	,~~ .BBT&RT.
	/......i... .: . . . i:	. . . . .:i..	i:.:.	.:.: ..:. ,,,,,

effectively the same as .~~~~~~~ ~N3TtiT. If the sweep

trigger is in jK!L@ mode, :&Z@l&,. . . . . . . . . . . .RlBT&T. executes a single sweep.

displays the trace memory for the active channel. This is the only memory display mode where the smoothing and gating of the memory trace can be changed. If no data has been stored in memory for this channel, a warning message is displayed.

provides access to a series of menus which are used to dehne and control all stimulus functions other than start, stop, center, and span. When the IMenu) key is pressed, the stimulus menu is

displayed.

/

sets the midpoint for !33$#%& I&#XTLj . It uses the entry controls to set a specified amplitude value vertically centered between the limits.

Key Definitions 9-27