HP 8753E manual Key is disabled if ‘~~~~~~~ is set to ~~~

.................... .........

~~~~~

.......................................................... ...... ......

specifies which limit segment in the table is to be modified. A maximum of three sets of segment values are displayed at one time, and the list can be scrolled up or down to show other segment entries. Use the entry block controls to move the pointer > to the required segment number. The indicated segment can then be edited or deleted. If the table of limits is

designated “EMPTY,” new segments can be added using the
.., ,l...;.;..;.....,......i....	::::.. ::.:.:. .....:~.~:~::-

:&fjB or :J* ..$<.....&xz.. s&key.

sets the center frequency of a subsweep in a list frequency sweep.

enters the IF bandwidth for the active segment in a swept list table.

enters absolute power values in the swept list table. The power values are restricted to the current power range setting.

If port power is uncoupled, power applies to the currently selected port, otherwise it applies to both ports (The list table only displays one port’s power values at time due to limited display area.) ‘lb set the alternate port’s power level, you must exit the edit list menus, select a measurement that activates the alternate port, and then re-enter the edit list menus.

This	‘“.:.:.....:.:.c,. ,,,.:	:.;::, ~:,~~~,.:::::::::::::~:,		.;;_.,....,.,,i
	key is disabled if ‘~~~~~~~ is set to ~~~
	._..........._	--.._	_.	/.................... 7:.i,“...-

sets the frequency or power span of a subsweep about a specified center frequency.

sets the start frequency of a subsweep.

sets the stop frequency of a subsweep.

leads to the select quadrant menu, which provides the capability of drawing quarter-page plots This is not used for pl-iIlthg.

provides access to the select disk menu.

The active entry area displays the letters of the alphabet, digits 0 through 9, and mathematical symbols lb define a title, rotate

the knob until the arrow t points at the first letter, then press
p,	/ : ,,..

~~~~~~. Repeat th& mt,il the complete title b de&&, ;::::,.:,.:. ;.../i .:._ ...::::.:..i....:::: 2........L.._SZ;.,.,.,:::..:,......~...#i

for a maximum of 50 characters As each character is selected, it is appended to the title at the top of the graticule.

prompts the analyzer to run a series of tests to determine a problem.

accesses a series of sequencing menus These allow you to create, modify, and store up to 6 sequences which can be run automatically.

activates editing mode for the segment titled “SEQl” (default title).

activates editing mode for the segment titled “SEQZ” (default title).

Key Definitions 9-41