HP 8753E manual Ad enter the &-ive where your &Sk is located

t
--+SWEEP/SWEEP-) R A WD A T A		--) E R R O R	+D A T A	+
A V E R A G I N G	A R R A Y S	CORPECTION	A R R A Y S
		jgTJ!q	+,

TRACE M A T H

-

I	I	I	I		I
GATING				T R A N S F O R M
( O P T	0 1 0 )			( O P T OIOJ

S M O O T H I N G+ FoRMAT +

A R R A Y S

pb6lOld

	Figure 4-12. Data Processing Flow Diagram
Note	If the analyzer has an active two-port measurement calibration, all
	four S-parameters will be saved with the measurement results All four
	S-parameters may be viewed if the raw data array has been saved.

1.If you want to title the displayed measurement, refer to “Titling the Displayed Measurement,” located earlier in this chapter.

3.Choose one of the following disk drives:

a. Connect an external disk drive to the analyzer’s HP-IB connector, and coniigure as

follows:	..,. ___
.::.::.lilii		ad enter the &-ive where your &Sk is located,
b. press @ ~~~~~~~~~~~~~
............/	i.i......~..........~. ......~;;..........._‘;,......... ,......;;z.......A..... ....A..ii./...A....w.

followed by (XJ).

_/_..........;.,..,... _

c. If your storage disk is partitioned, press ;;$Q@%&$2@,@J@@ and enter the volume number
..-	~.	_i:.::;:.

where you want to store the instrument state file.

e. Enter the HP-LB address of the peripheral, if the default address is incorrect (default = 00). Follow the entry by pressing (xl).

Printing, Plotting, and Saving Measursment Results 437