Korg Electric Keyboard manual Smpl 7.1 Insert Effect, 2 IFX, 119, 1a Utility

■5.2–1c: UTILITY

☞“Delete SMPL,” “Copy SMPL,” “Move SMPL,” “Rename SMPL,” “SMPL To Stereo,” “Delete MS,” “Copy MS,” “Move MS,” “Rename MS,” “MS To Stereo/MS To Mono,” “Conv. To Prog,” “Keyboard Disp.” (1.1–3f)

SMPL 7.1: Insert Effect

Here you can make insert effect settings for use in Sampling mode.

When you set “BUS” (1.1–3a) to IFX, the external input sound from the rear panel AUDIO INPUT 1 and 2 jacks will be sent to IFX (insert effect). By selecting insert effect and making settings in this page, you can apply the insert effect to the signal entering through the external input, and sam- ple the result.

☞For details on insert effect, refer to p.155 “7. Effect Guide.”

In Sampling mode, master effects 1 and 2 and the mas- ter EQ cannot be used.

Insertion effect settings in Sampling mode are not backed up when the power is turned off. If you wish to keep the insertion effect settings, you can use “Copy Insert Effect” (7.1–1a).

For example, you can copy the insertion effect settings of Sampling mode to a program or combination in order save them. When you write the program or com- bination, the settings will be saved in internal memory. In Sampling mode, you can use “Copy Insert Effect” (7.1–1a) to copy these effect settings from the program or combination back into Sampling mode and use them.

7.1–1: Setup

Here you can select insert effects, switch them on/off, make chain settings, and specify the pan of the sound after pass- ing through the insert effect.

These parameters are the same as in Program mode. ☞ Pro- gram mode “7.1–2: Setup”

7.1–2: IFX

Sets the effect parameters for the IFX effect that you selected in the Setup page (☞ p.164–).

Effect Dmod (dynamic modulation) is controlled by the global MIDI channel specified in “MIDI Channel” (GLOBAL 2.1–1a).

7.1 5.2 5.1 4.1 3.1 2.1 1.1 SMPL

7.1–1a

■7.1–1a: UTILITY

☞“Copy Insert Effect” (PROG 7.1–1c), “Select by Category” (PROG 7.1–2c)

119