Korg Electric Keyboard 05 St.Gate, 06 OD/HiGain Wah, 166, Stereo Gate, Overdrive/Hi.Gain Wah

	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
i	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

e: Low Offset, f: Mid Offset, g: High Offset

These parameters set the gain of the trigger signal.

For example, if you do not want to apply compression to the high range, reduce the “High Offset” value down below the “Thresh- old” level. In this way, the high range limiter will not respond, and compression will not be applied.

05: St.Gate

(Stereo Gate)

This effect mutes the input signal if its level is lower than the specified level. It also reverses the on and off operation of the gate, and uses Note On and Off messages to turn the gate on and off.

c: Threshold, d: Attack, e: Release

This parameter sets the signal level below which Gate is applied when “Envelope” is set to L/R Mix, L Only, or R Only.

The Attack and Release parameters set the Gate attack time and release time.

Gate - Threshold

Output Level

Threshold

Louder

Louder

Input Level

Gate - Attack / Release

Threshold

Dry
Wet	Attack=1
	Release=1
Wet	Attack=100
	Release=100

Stereo In - Stereo Out

Left

+

Envelope Select

Right

Gate+Dmpr

Delay

Envelope - Control

Envelope - Control

Delay

Wet / Dry

Gate

Gate

Wet / Dry

Attack Release

g: Delay

This parameter sets the delay time of the Gate input. If the sound has a very fast attack, increase the delay time so that the signal will be input after the Gate is opened. This will preserve the attack part of the sound.

Envelope (Envelope Select)	Dmod, L/R Mix, L Only, R Only
a Selects from Control via the modulation source, mixing the left and
right signals, Only left, and Only right		☞ ,
Env. Dmod Src (Envelope Dmod Source)		Off...G2+Dmp

bSelects the modulation source that controls the gate when Envelope = Dmod

c	Threshold		0...100
	Sets the level to which the Gate is applied			☞
d	Attack		1...100
	Sets the attack time			☞
e	Release		1...100
	Sets the release time			☞
f	Polarity			+, –
	Switches between non-reversed and reversed Gate on/off			☞
g	Delay (Delay Time)		0...100ms
	Sets the delay time of the gate input			☞
	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
h	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

a: Envelope, b: Env. Dmod Src

The “Envelope” parameter selects whether the gate on/off is trig- gered by the level of the input signal, or controlled directly by the modulation source. The Src parameter specifies the modulation source, selected from Off to G2+Dmod.

With “Envelope” = L/R Mix, the left and right channel signal mix- ture will trigger the gate on/off. When L Only or R Only is selected, the gate is controlled by either of the channel signals.

f: Polarity

This parameter reverses the Gate on/off operation. With a nega- tive value, the gate is closed when the input signal level exceeds the Threshold. The gate operation controlled by the modulation source is also reversed.

06: OD/HiGain Wah

(Overdrive/Hi.Gain Wah)

This distortion effect utilizes an Overdrive mode and a Hi- Gain mode. Controlling the wah effect, the 3-band EQ, and the amp simulation will allow you to create versatile distor- tion sounds. This effect is suitable for guitar and organ sounds.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left			Wet / Dry
		Mode: Overdrive / Hi-Gain
Pre Low-cut		Drive
		3 Band PEQ
+	Wah	Driver	Amp Simulation
		Output Level
		Direct Mix
Right			Wet / Dry
D-mod

	Wah	Off, On
	Switches Wah on/off	☞ ,
	(Source)	Off...Tempo
a Selects the modulation source that switches the Wah on and off
	(Sw)	Tggl, Mmnt
	Selects the switching mode for the modulation source that switches
	the Wah on and off		☞

Sweep Rng (Wah Sweep Range)		–10...+10
Sets the range of Wah		☞ ,
b
Src (Source)		Off...Tempo
Selects the modulation source that controls the Wah		☞
Mode (Drive Mode)	Overdrive, Hi-Gain
Switches between overdrive and hi-gain distortion

c

	Drive	1...100
	Sets the degree of distortion	☞
d	Pre Low-cut	0...10
	Sets the low range cut amount of the distortion input	☞

166