Korg Electric Keyboard manual 1b Master FX Chain, 1c MEQ Ctrl

7.2–1b: Master FX Chain

MFX Chain	[Off, On]
Direction (Chain Direction)
	[MFX1→ MFX2, MFX2→ MFX1]
Signal (Chain Signal)	[LR Mix, L Only, R Only]
Level (Chain Level)	[000...127]

This is the same as in Program mode. Refer to “PROG 7.2–1: Setup.”

7.2–1c: MEQ Ctrl

MEQ Ctrl (MEQ Control Ch) [Ch01...16, G ch]

Specifies the MIDI channel that will control dynamic modulation (Dmod) for the master EQ.

G ch: The effect will be controlled on the global MIDI chan- nel “MIDI Channel” (GLOBAL 2.1–1a).

7.2–1d: Master EQ Gain [dB]

Low	[–18.0...+18.0]
Mid	[–18.0...+18.0]
High	[–18.0...+18.0]

This is the same as in Program mode. (☞ PROG 7.2–1: Setup)

■7.2–1e: UTILITY

☞“Memory Status,” “Solo Selected Track,” “FF/REW Speed,” “Set Location” (1.1–1d), “Select by Category” (PROG 7.2–1d)

For details on how to select the desired utility function, refer to “PROG 1.1–1c: UTILITY.”

Copy Master Effect

☞p.28 PROG 7.2–1d

Note, the MIDI control channel specified in “Control Chan- nel” of the MFX 1 and 2 pages will not be copied.

Swap Master Effect

☞p.29 PROG 7.2–1d

Note, the MIDI control channel specified in “Control Chan- nel” of the MFX 1 and 2 pages will not be swapped.

7.2–2: MFX1 (Master Effect1)

7.2–3: MFX2 (Master Effect2)

Here you can set the parameters of the “Master Effect1” and “Master Effect2” effects that were selected in the Setup page (☞ p.164–).

7.2–2a

■7.2–2(3)a: UTILITY

☞“Memory Status” (1.1–1d)

7.2–4: MEQ (Master EQ)

The master EQ is a three-band stereo EQ. It is used to per- form overall equalizing (tonal adjustment) on the sound from the L/R bus immediately before it is output to AUDIO OUTPUT (MAIN OUT) L/MONO and R (☞ p.209).

7.2–4a

■7.2–4a: UTILITY

☞“Memory Status” (1.1–1d)

86