Korg Electric Keyboard manual Midi transmission when Triton Le‘s controllers are Operated, 224

MIDI transmission when

the TRITON Le‘s controllers are

operated

The following table shows the relation between the MIDI messages that are transmitted when the TRITON Le’s con- trollers are operated, and the AMS (alternate modulation source) or DMS (dynamic modulation source) that corre- spond to each MIDI message. # indicates a fixed function, and * indicates an assignable function.

When one of the TRITON Le’s controllers is operated, the corresponding or the assigned control change will be trans- mitted. Pitch Bend messages will be transmitted only when the joystick is moved in the X (horizontal) direction. The operation in each mode is described below. (Explanations are given only for control changes, but the same applies to pitch bend as well.)

Program mode

When one of the TRITON Le’s controllers is operated, a con- trol change message will be transmitted on the global MIDI channel.

If a REALTIME CONTROLS B-mode knob [1]–[4] is set to Master Volume, the universal exclusive message Master Volume will be transmitted.

Combination mode

When one of the TRITON Le’s controllers is operated, a con- trol change message will be transmitted on the global MIDI channel.

Simultaneously, the message will also be transmitted on the MIDI channel (“MIDI Channel” COMBI 3.1–1a) of any tim- bre whose “Status”(COMBI 3.1–1a) is EXT or EX2.

When one of the TRITON Le’s controllers is operated, its effect will apply to any timbre whose “Status” is INT and whose “MIDI Channel” setting is either Gch or the same as the global MIDI channel.

In the case of Master Volume, the universal exclusive message Master Volume will be transmitted only on the global MIDI channel.

You can make settings for MIDI Filter (COMBI 4.1–4.4) to enable or disable control changes and controllers for each timbre. When checked, the above operations will be enabled.

Effect dynamic modulation can be controlled when the “Control Ch (Control Channel)” (COMBI 7.1–1b, 7.2–1a, 7.2– 1c) setting for IFX, MFX1, 2, or MEQ is either set to Gch or to the same channel as the global MIDI channel. (In the case of All Rt., control is possible on the MIDI channel of any routed timbre.)

224