Korg Electric Keyboard manual Wah-AmpSim, Deci-AmpSim, Deci-Comp, 206

83: Wah–AmpSim

(Wah/Auto Wah – Amp Simulation)

This effect combines a mono-type wah and an amp simula- tion. You can change the order of the effect connection.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left				Wet / Dry
			Routing
	Wah/Auto Wah
			Amp Simulation
+		Wah	Amp Simulation Filter
Right		Sweep Mode		Wet / Dry
	Envelope Auto
	D-mod	D-mod
		LFO
	LFO

	[WAH] Freq Btm (Frequency Bottom)		0...100
a	Sets the lower limit of the wah center frequency		☞ Fx:09
	Top (Frequency Top)		0...100
	Sets the upper limit of the wah center frequency		☞ Fx:09
	Swp Mode (Sweep Mode)		Auto, Dmod, LFO
	Selects the control from auto-wah, modulation source, and LFO
b			☞ Fx:09,
	Src (Source)		Off...Tempo
	Selects the modulation source for the wah when Swp Mode=Dmod
c	lfoF (LFO Frequency)		0.02...20.00Hz
	Sets the LFO speed
	Resonance		0...100
d	Sets the resonance amount
	LPF (Low Pass Filter)		Off, On
	Switches the wah low pass filter on and off
e	[AMP] Amplifier Type		SS, EL84, 6L6
	Selects the type of guitar amplifier
f	[Routing]	WAH →	AMP, AMP → WAH
	Switches the order of the wah and amp simulation connection
	W/D (Wet/Dly)		Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
g	(Source)		Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)		–100...+100
	Sets the modulation amount of the effect balance

84: Deci–AmpSim

(Decimator – Amp Simulation)

This effect combines a mono-type decimator and an amp sim- ulation. You can change the order of the effect connection.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left			Wet / Dry
		Routing
	Decimator	Amp Simulation
Resolution		Output Level
+	Decimator	Amp Simulation Filter
Pre LPF	High Damp
Right			Wet / Dry

	[DECI] Pre LPF	Off, On
a	Turn the harmonic noise caused by lowered sampling on and off
		☞ Fx:14
b	High Damp	0...100%
	Sets the ratio of high-range damping
c	Sampling Freq (Sampling Frequency)	1.00k...48.00kHz
	Sets the sampling frequency
d	Resolution	4...24
	Sets the data bit length	☞ Fx:14

e	Level (Output Level)	0...100
	Sets the decimator output level	☞ Fx:14
f	[AMP] Amplifier Type	SS, EL84, 6L6
	Selects the type of guitar amplifier
g	[Routing]	DECI→ AMP, AMP→ DECI
	Switches the order of the wah and amp simulation connection
	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
h	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

85: Deci–Comp

(Decimator – Compressor)

This effect combines a mono-type decimator and a compres- sor. You can change the order of the effect connection.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left			Wet / Dry
		Routing
	Decimator		Compressor
Resolution		Output Level
+	Decimator		Comp
Pre LPF		High Damp	Output Level
Right			Wet / Dry
		Envelope - Control

	[DECI] Pre LPF	Off, On
	Turn the harmonic noise caused by lowered sampling on and off
a		☞ Fx:14
	High Damp	0...100%
	Sets the ratio of high-range damping
b	Sampling Freq (Sampling Frequency)	1.00k...48.00kHz
	Sets the sampling frequency
c	Resolution	4...24
	Sets the data bit length	☞ Fx:14
d	Level (Output Level)	0...100
	Sets the decimator output level	☞ Fx:14
e	[CMP] Sensitivity	1...100
	Sets the sensitivity	☞ Fx:02
	Attack	1...100
f	Sets the attack level	☞ Fx:02
	Level (Output Level)	0...100
	Sets the compressor output level	☞ Fx:02
g	[Routing]	DECI→ CMP, CMP→ DECI
	Switches the order of the decimator and compressor connection
	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
h	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

206