Korg Electric Keyboard Filter/Dynamic, No Effect, 01 St.Amp Sim, 02 St.Compressor, 03 St.Limiter

Filter/Dynamic

Filter and dynamics control effects

00: No Effect

Select this option when you do not wish to use any effects. The Insert Effect section outputs unprocessed signals and the Master Effect section mutes the output.

01: St.Amp Sim

(Stereo Amp Simulation)

This effect simulates the frequency response characteristics of guitar amplifiers. It is also effective for organ and drum sounds.

Stereo In - Stereo Out

Left

Wet / Dry

Amp Simulation Filter

Amp Simulation Filter

Right

Wet / Dry

Amplifier Type SS, EL84, 6L6

aSelect between three types of guitar amp simula- tors

	W/D (Wet/Dry)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
b	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

02: St.Compressor

(Stereo Compressor)

This effect compresses the input signal to regulate the level and give a “punchy” effect. It is useful for guitar, piano, and drum sounds. This is a stereo compressor. You can link left and right channels, or use each channel separately.

Stereo In - Stereo Out
Left			Wet / Dry
EQ Trim
	LEQ	HEQ
		Compressor	Output Level
		Envelope - Control
Envelope Select		Envelope - Control
		Compressor	Output Level
EQ Trim	LEQ	HEQ
Right			Wet / Dry

	Envelope (Envelope Select)	L/R Mix, L/R Individually
a	Determines whether the left and right channels are linked or used
	separately	☞
b	Sensitivity	1...100
	Sets the sensitivity	☞
c	Attack	1...100
	Sets the attack level	☞

	Level (Output Level)	0...100
	Sets the output level of the compressor	☞ ,
d	(Source)	Off...Tempo
	Selects the modulation source for the compressor output level
	(Amount)	–100...+100
	Sets the modulation amount of the compressor output level
e	Pre EQ Trim	0...100
	Sets the EQ input level
	LoEQ (Pre Low EQ Gain)	–15.0...+15.0dB
f	Sets the gain of Low EQ
	HiEQ (Pre High EQ Gain)	–15.0...+15.0dB
	Sets the gain of High EQ
	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
g	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

a: Envelope

This parameter selects whether the left and right channels are linked to control both signals simultaneously, or whether each channel is controlled independently.

b: Sensitivity, d: Level

The “Sensitivity” parameter sets the sensitivity of the compressor. If this parameter is set to a higher value, lower level sounds will be boosted. With a higher Sensitivity, the overall volume level is higher. To adjust the final volume level, use the “Level” parame- ter.

Level		Compressor - Sensitivity
	Wet
		Sensitivity=100
Louder	Dry	Sensitivity=40
		Time

c: Attack

This parameter controls the attack level.

Compressor - Attack

Level

Attack=80

Attack=20

Wet

Dry

Time

03: St.Limiter

(Stereo Limiter)

The Limiter regulates the input signal level. It is similar to the Compressor, except that the Limiter compresses only signals that exceed the specified level to lower unnecessary peak sig- nals. The Limiter applies a peaking-type EQ to the trigger sig- nal (which controls the degree of the Limiter effect), allowing you to set any band width to be covered. This effect is a stereo limiter. You can link left and right channels, or use each chan- nel individually.

Stereo In - Stereo Out
Left	Wet / Dry
	Gain Adjust
Side PEQ	Limiter
Envelope - Control	Trigger Monitor
+
Envelope - Control
Envelope Select	Limiter
	Gain Adjust
Right	Wet / Dry

164