Korg Electric Keyboard manual 62 P4EQ-M.Dly, Comp-Wah, 197, Parametric 4-Band EQ Multitap Delay

62: P4EQ–M.Dly

(Parametric 4-Band EQ – Multitap Delay)

This effect combines a mono-type four-band parametric equalizer and a multitap delay.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left		Wet / Dry
Parametric 4Band EQ	Multitap Delay
+	Feedback
	Delay	(2)
Trim	High Damp (1)	Mt.Dly Wet / Dry
Right		Wet / Dry

a	[PEQ] Trim	0...100
	Sets the parametric EQ input level
	B1 (Band1 Cutoff)	20...1.00kHz
	Sets the center frequency of Band 1
b	Q	0.5...10.0
	Sets the bandwidth of Band 1	☞ Fx:06
	G (Gain)	–18...+18dB
	Sets the gain of Band 1
	B2 (Band2 Cutoff)	50...5.00kHz
	Sets the center frequency of Band 2
c	Q	0.5...10.0
	Sets the bandwidth of Band 2	☞ Fx:06
	G (Gain)	–18...+18dB
	Sets the gain of Band 2
	B3 (Band3 Cutoff)	300...10.00kHz
	Sets the center frequency for Band 3
d	Q	0.5...10.0
	Sets the bandwidth of Band 3	☞ Fx:06
	G (Gain)	–18...+18dB
	Sets the gain of Band 3
	B4 (Band4 Cutoff)	500...20.00kHz
	Sets the center frequency for Band 4
e	Q	0.5...10.0
	Sets the bandwidth of Band 4	☞ Fx:06
	G (Gain)	–18...+18dB
	Sets the gain of Band 4
	[DLY] T1 (Tap1 Delay)	0...680ms
f	Sets the Tap1 delay time
	T2 (Tap2 Delay)	0...680ms
	Sets the Tap2 delay time
	T1 Level (Tap1 Level)	0...100
g	Sets the Tap1 output level	☞ Fx:45
	T2 Fb (Tap2 Feedback)	–100...+100
	Sets the Tap2 feedback amount
	Dly W/D (Delay Wet/Dry)	Dry, 2:98...98:2, Wet
h	Sets the multitap delay effect balance
	HiDamp (High Damp)	0...100%
	Sets the damping amount in the high range	☞ Fx:43
	W/D (Wet/Dly)	Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
i	(Source)	Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)	–100...+100
	Sets the modulation amount of the effect balance

63: Comp–Wah

(Compressor – Wah/Auto Wah)

This effect combines a mono-type compressor and a wah. You can change the order of the connection.

Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left					Wet / Dry
			Routing
		Compressor	Wah/Auto Wah
	+	EQ Trim LEQ HEQ
		Comp		Wah
		Output Level
Right			Sweep Mode		Wet / Dry
		Envelope - Control	Envelope	Auto
			D-mod D-mod
				LFO
			LFO
a	[CMP] Sensitivity				1...100
	Sets the sensitivity				☞ Fx:02

	Attack		1...100
b	Sets the attack level		☞ Fx:02
	Level (Output Level)		0...100
	Sets the compressor output level		☞ Fx:02
c	Pre EQ Trim		0...100
	Sets the EQ input level
	LoEQ (Pre Low EQ Gain)		–15...+15dB
d	Sets the gain of Low EQ
	HiEQ (Pre High EQ Gain)		–15...+15dB
	Sets the gain of High EQ
	[WAH] FreqBtm (Frequency Bottom)		0...100
e	Sets the lower limit of the wah center frequency		☞ Fx:09
	Top (Frequency Top)		0...100
	Sets the upper limit of the wah center frequency		☞ Fx:09
	Swp Mode (Sweep Mode)		Auto, Dmod, LFO
	Selects the control from auto-wah, modulation source, and LFO
f			☞ Fx:09,
	Src (Source)		Off...Tempo
	Selects the modulation source for the wah when Swp Mode=Dmod
	lfoF (LFO Frequency)		0.02...20.00Hz
	Sets the LFO speed
g	Res (Resonance)		0...100
	Sets the resonance amount
	LPF (Low Pass Filter)			Of, On
	Switches the wah low pass filter on and off
h	[Routing]	CMP →	WAH, WAH → CMP
	Switches the order of the compressor and wah connection
	W/D (Wet/Dly)		Dry, 1:99...99:1, Wet
	Sets the balance between the effect and dry sounds
i	(Source)		Off...Tempo
	Selects the modulation source of the effect balance
	(Amount)		–100...+100
	Sets the modulation amount of the effect balance

Effect

197