97
Operator Panel Menus
NPAMode Off
Auto*
NPAis a mode of bidirectional communication that follows the conventions defined in
Network
Printing Alliance Protocol, A Printer/Host Control Specification Developedby the NPA
.NPA
moderequires special processing of the pr int data.
IfNPA Mode is set to On, the data received must be in NPA format. If not, it is rejected as bad
data.If NPA Mode is set to Off, the printer does not perform any NPAprocessing. If NPA Mode
is set to Auto, the printer examines the data to determine the format and then processes it in
either format.
The NPAMode setting in the LOCALTALKMENU applies onlyto the LocalTalkinterface
connection.
Note: Changing the NPAMode setting automatically resets the printer.
LocalTalkBuffer Disabled
Auto*
6K to maximumsize allowed
Youcan configure the size of the LocalTalkinput buffer to meet the requirements of your
system.I fthe limited size of the input buffer is preventing you from continuing work in your
softwareapplication each time you send a job to the printer, you may want to increase the
buffer size.
Them aximumsize available for modification depends on the amount of memory in your
printer,the size of the other link buffers, and whether Resource Save is set to On or Off.To
maximizethe range for the LocalTalk buffer size, you can disableor reduce the sizeof the
parallel,ser ial, infrared,and USB buffers.
Choose Auto to let the printer calculate a buffer size proportional to the total amount of
availableprinter memory. In most cases, Auto is the recommended setting.
Note: Changing the LocalTalkBuffer setting automatically resets the printer.
NPAHosts 110(2*)
Usethis setting to specify the maximum number of NPA hosts that can register for NPAprinter
alerts. When the number of hosts registered forNPA alerts exceeds the quantity specified by
NPAHosts, any additional hosts attempting to register for alerts are ignored.
Note: Changing the NPAHosts setting automatically resets the printer.
LocalTalkName LexmarkOptra M410 or Lexmark Optra M412
This setting identifies the printer model name stored in printer memory.It cannot be modified
throught he operatorpanel.
LocalTalkMenu (continued)
MenuItem Values
*Factorydefault