221
Closing the Printer System Board
4Holdthe side door slightly to the left of the printer
and place the latches located on the back edge of
the side door against the metal shield.
Theedge of the metal shield fits into the latches. The
top latch fits inside the back of the printer.
5Close the side door,pressing on the side door
latches to snap it into place.
6Close the upper and lower front doors.
7Reconnect all cables to the back of the printer.
8Reconnect the printer power cord to the printer
and a properly grounded electrical outlet.
9Turnthe printer power On (|).
10 Make sure the Readymessage appears on the oper-
ator panel display.
If an errorm essage appears, see “Understanding
Printer Messages”on page 151.
Note: Toverify options are
installed properly,see “Ve rifyin g
the Installation of Options”on
page 229.