When inserting the diskette, the label of the diskette should face upwards, and the notch in the side of the diskette (5 1/4 inch diskette) should be on the left. When you hear a click, indicating that the diskette has been fully inserted, press down the latch on drive A until you feel the latch lock.
NOTE: The procedure is essentially the same whether you are using the 5 1/4 inch floppies or the 3 1/2 inch diskette. However, if you are using the 5 1/4 inch floppies, insert the diskette labeled “1 of 2“ at this first step.
4When you are ready, press any key.
The red
WARNING: Do not remove a diskette from the drive while the red
When the system has read the first part of the diskette, this message is displayed:
Insert TARGET diskette in drive A:
Strike any key when ready . . .
5When the red
Formatting While Copying
appears on the screen.
NOTE: Depending on the amount of memory on your PC, the system may prompt you to swap diskettes during diskcopy.
When the copying process is finished, you see:
Copying complete
Copy another diskette (Y/N)?
6If you are using the 3 1/2 inch diskette, type n. You don’t need to press
[ ↵ ] .
If you are copying the 5 1/4 inch diskettes, type y. Then insert the second diskette (labeled “2 of 2“ ). (After it has been completely copied, type n and go on to the next step).
7 When the C> prompt appears, remove the duplicate diskette, prepare an appropriate label, such as “CMS Duplicate Copy,” and apply the label to the diskette.
NOTE: Label the 5 1/4 inch diskettes “CMS Duplicate Copy 1” and “CMS Duplicate Copy 2,” respectively.
8Store each original diskette in a safe place.
You are now ready to install the CMS software.
