Filling the New Fuser Unit with Fuser Oil

Use the following procedure to fill the new fuser unit with fuser oil.

<2-4> CAUTION:

If spilled, fuser oil causes hazardous surfaces. Prevent anyone from entering the area until the surface is clean.

1.Open the oil recycle bottle and slowly pour the oil saved from the used fuser unit into the oil bottle holder of the new fuser unit.

2.Replace the inner seal (see step 4 on page 5–22)and close the oil recycle bottle. Clean the bottle with a towel and store it in the box in which it was shipped.

Attention:

Do not shake the fuser oil bottle. Oil can spill out.

3.Lower the fuser oil bottle cover [1].

4.Hold a towel on the top of the oil bottle and turn the bottle upside down. Hold the oil bottle with its label [2] facing out and put the bottle in the oil bottle holder.

5.Align the bottle with the bottle holder. Firmly push down [1] on the bottle until it locks into place.

5–30IBM Network Color Printer Operator’s Guide

Page 104
Image 104
IBM S544-5361-01 quick start Filling the New Fuser Unit with Fuser Oil