5–16 IBM Network Color Printer Operator’s Guide

Replacing the Fuser Oil Bottle
This section tells you how to replac e the fuser oil bottle. Fuser oil is used in the
final stage of the printing process. Wh en the oil level is low or when you see
the FUSER OIL LOW message on the display panel, re pla ce the fuser oil bottle
with a new one using the instructions th at fo llo w.
<2-4> CAUTION: If spilled, fuser oil causes hazardous surfaces; prevent anyone from entering
the area until the surface is clean.
Attention:
Do not use the printer without a fuser oil bottle installed. If you do, you may damage
the printer.

Removing the Old Fuser Oil Bottle

Use the following procedure to remov e t he old fuser oil bottle.
1. Open the front door.
2. Lower the fuser oil bottle cover [1]. Lift the oil bottle [2] from the oil bottle
holder and put a towel under the bottle to pre vent drops of oil from spilling
on the floor.