LOREX Technology LH330 EDGE2, LH340 EDGE3, LH3481001C8B Configuring the Motion Alarm Schedule

Using the Main Menu

2Configure the following:

•Vloss Response Time: Select the time (in seconds) that the buzzer and on-screen message will turn on after a Video loss event.

•Response Duration: Select the time (in seconds) for the DVR to record after a motion event. This also controls the duration of the buzzer and on-screen message.

NOTE: When the buzzer is activated, press any button or right-click to stop it. This does not disable the buzzer for future events.

•Alarm Full Screen: Select O if you want the DVR to display events (for example, when motion is detected or video loss occurs) in full screen; select X to have the DVRremaininitscurrentviewwhenevents occur.

3Right-click to save your settings and return to the Alarm Menu.

Configuring the Motion Alarm Schedule

The Motion Alarm Schedule allows you to enable or disable motion events at certain times. This can be useful if you want to set up your DVR to record continuously during business hours and record motion events only outside of business hours.

To configure the Motion Schedule:

1From the Alarm Menu, click Alarm Setup. The Alarm Setup Menu opens.

2Click Motion Alarm Schedule. The Motion Alarm Schedule opens.

Motion Alarm Schedule Range Selectors

3Click the boxes to switch each half-hour between Working and Non-working hours. Use the Range Selectors to switch multiple boxes at once.

•Enabled (yellow): Motion events will be enabled during these hours.

•Disabled (green): Motion events will be disabled during these hours.

4Right-click until you have existed all menus to save your changes.

Configuring the DVR for Motion Recording Only

Use the steps below to configure the DVR to disable continuous recording and only record footage that has motion. This allows you to record for a much longer time before the hard drive is full. You can do this on one, some, or all of your cameras.

NOTE: By default, the DVR will overwrite the oldest recordings whentheharddriveisfull.Itcan also be configured to stop recording when the harddriveis full. For details, see “Changing the Record Mode” on page 37.

41