SANRAD V-Switch manual General Configuration Parameters, 170

This command is available only after the V-Switch is initialized with the init command.

General Configuration Parameters

After the initial V-Switch configuration, you may want to change one or more of the V-Switch parameters. For example: You may need to change the system clock to adjust to Daylight Savings Time. You can also use this command to add contact information of whom to contact in the event of technical difficulties.

device set

You can define or change thirteen parameters using this command:

	SWITCH	PARAMETER	DEFINITION	STATUS	EXAMPLE
If you are working in -n		NAME	USER-ASSIGNED	OPTIONAL	VSwitch1
a V-Switch cluster,			NAME FOR THE V-
the changes must be			SWITCH
configured in both V-
Switches.
	-ip	MANAGEMENT IP	IP ADDRESS OF	OPTIONAL	212.199.43.47
		ADDRESS	THE MANAGEMENT
			PORT
	-im	MANAGEMENT IP	IP MASK FOR THE	OPTIONAL
		MASK	MANAGEMENT PORT	DEFAULT:
				255.255.255.0
	-p	UDP PORT	PORT THROUGH	OPTIONAL
			WHICH ALL UDP	DEFAULT:	161
			COMMUNICATIONS
			WILL FLOW –
			NAMELY FOR SNMP
	-if	INTERFACE ALIAS	ALIAS OF PORT FOR	OPTIONAL
			MANAGING V-	DEFAULT: MGMT
			SWITCH	(ETH1 OR
				MGMT)
	-d	DATE	LOCAL DATE	OPTIONAL	21/07/2002
	-t	TIME	LOCAL TIME	OPTIONAL	13:30
	-c	CONTACT	CONTACT PERSON	OPTIONAL	AnnaLevin
			IN THE EVENT OF A
			SYSTEM
			MALFUNCTION
	-loc	LOCATION	LOCATION OF THE	OPTIONAL	ext4838
			CONTACT PERSON

170 SANRAD V-Switch User Manual