SANRAD V-Switch manual Init -n VSwitch1, Sample Configurations 251

Open your terminal emulation program and set the system parameters as follows:

Table 64: Console Configuration Parameters

PARAMETER	SYSTEM REQUIREMENT
CONFIG SERIAL PORT	COM
BITS PER SECOND	115200
DATA BITS	8
PARITY	NONE
STOP BITS	1
FLOW CONTROL	NONE

STEP 5. LOGIN TO THE MANAGEMENT PORT

From the open terminal emulation window, press Enter on your keyboard to open the V-Switch 3000 Login window.

Figure 99. V-Switch 3000 Login Window

Enter the default user name, sanrad, and password, sanrad, and press Enter on your keyboard. The CLI prompt > appears. You are now logged in and ready to begin configuring your V-Switch for volume virtualization and exposure.

STEP 6. INITIALIZE V-SWITCH

From the open terminal emulation window, use the CLI command init to name the V-Switch.

init –n VSwitch1

Use the CLI command ip config set to assign an IP address to the

network port Eth 1. Configure the port as active (1) to allow active communications through the port.

ip config set –ip 172.17.200.174 –if eth1 –im 255.255.255.0 –act 1

Sample Configurations 251