SANRAD V-Switch manual Adding User Login Profiles

SWITCH	PARAMETER	DEFINITION	STATUS	EXAMPLE
-rcom	READ COMMUNITY	COMMUNITY TO	OPTIONAL	public
		GET INFORMATION	DEFAULT:
			PUBLIC

-wcom

-trap

WRITE COMMUNITY	COMMUNITY TO SET	OPTIONAL
	INFORMATION	DEFAULT:
		PRIVATE
TRAP	TO SEND TRAPS TO	OPTIONAL
	MANAGER	YES: SEND
		NO: DO NOT
		SEND
		DEFAULT: YES

private

yes

Example

An SNMP manager is added on IP address 212.199.43.96. It receives traps through port 162. The manager receives information through the public community and writes information through the private community.

snmp manager add –ip 212.199.43.96 –p 162 –rcom public – wcom private –trap yes

All CLI names and aliases are case sensitive.

Adding User Login Profiles

After logging in to a V-Switch, a total of ten user profiles (name plus password) can be configured on a V-Switch using the CLI command admin add. The default user name and password sanrad can be maintained or removed. The user name can have from one to twenty characters. The user password can have from six to twelve characters. Both fields are case sensitive and accept all characters, including spaces.

Example

admin add

You need to define two parameters to configure a user profile:

SWITCH	PARAMETER	DEFINITION	STATUS	EXAMPLE
-un	USER NAME	USER NAME	MANDATORY	Joe Cool
-pw	PASSWORD	USER PASSWORD	MANDATORY	123456
			6 CHARACTER
			MINIMUM

Example

admin add –un Joe Cool –pw 123456

Chapter 4: V-Switch Configuration 55