SANRAD V-Switch manual Sample Configurations 261, Attach and View Storage Devices

STEP 1. ATTACH AND VIEW STORAGE DEVICES

Attach the legacy JBOD to the V-Switch and configure the storage port communications as needed. See “Configuring the Storage Ports,” page 57.

Use the CLI command storage show to view the attached storage.

Table 69:	Legacy JBOD Disks
Alias	Entity Name	LUN	Oper. Status	Subdisk
Stor_1	200507606058c90	0	Enabled	entire
Stor_2	2000002037f88fb8	0	Enabled	entire
Stor_3	2000002037c32b1f	0	Enabled	entire
Stor_4	2000002037c32450	0	Enabled	entire

Next, attach the new JBOD to the V-Switch and configure the storage port communications as needed.

Use the CLI command storage show to view the attached storage. The

legacy JBOD disks are Stor_1 through Stor_4. The new JBOD disks are Stor_5 through Stor_8.

Table 70:	Legacy + New JBOD Disks
Alias	Entity Name	LUN	Oper. Status	Subdisk
Stor_1	200507606058c90	0	Enabled	entire
Stor_2	2000002037f88fb8	0	Enabled	entire
Stor_3	2000002037c32b1f	0	Enabled	entire
Stor_4	2000002037c32450	0	Enabled	entire
Stor_5	500708206059f880	0	Enabled	entire
Stor_6	500003504206a683	0	Enabled	entire
Stor_7	500065470490f321	0	Enabled	entire
Stor_8	500000024364h764	0	Enabled	entire

STEP 2. CREATE SIMPLE VOLUMES

Use the CLI command volume create simple to create a simple volume from each disk.

Use one standard for naming the legacy JBOD simple volumes and another for naming the new JBOD simple volumes. This will provide a visual cue when it is time to designate the source volume to replicate from.

volume create simple –vol OS1 –d Stor_1

volume create simple –vol OS2 –d Stor_2

. . .

volume create simple –vol NS3 –d Stor_7

volume create simple –vol NS4 –d Stor_8

Sample Configurations 261