SANRAD V-Switch manual Storage blink activate -s Stor1 -t, Storage blink abort, Storage set, Wce

storage blink activate –s Stor_1 –t 120

Use the CLI command storage blink abort to stop the blinking before the end of the set time.

storage blink abort

You need to define one parameter to stop blinking a storage device:

SWITCH	PARAMETER	DEFINITION	STATUS	EXAMPLE
-s	STORAGE DEVICE	ALAIS OF DEVICE	MANDATORY	Stor_1
		TO BLINK

Once a storage device has been identified, use the CLI command storage set to change the device alias or include helpful information on the device.

storage set

SWITCH PARAMETER DEFINITION STATUS EXAMPLE

-s

-na

-info

STORAGE ALIAS	STORAGE ALIAS TO	MANDATORY
	MODIFY
NEW ALIAS	NEW ALIAS FOR	OPTIONAL
	STORAGE
INFORMATION	INFORMATION ON	OPTIONAL
	STORAGE TO SET

Stor_1

Disk2JBOD5

save_for_snap shots

Example:

The alias of Stor_1 is changed to Disk2JBOD5 for easier identification and it is noted to save the disk for snapshots.

storage set –s Stor_1 –na Disk2JBOD5 –info save_for_snap shots

The V-Switch supports write cache enabling for increased performance. Use the CLI command storage disk set to enable or disable the write cache.

storage disk set

You need to define two parameters to change a device’s write cache setting:

SWITCH PARAMETER DEFINITION STATUS EXAMPLE

-d

-wce

DISK	DISK DEVICE	MANDATORY
WRITE CACHE	WRITE CACHE	MANDATORY
ENABLED	FUNCTION	YES OR NO

Disk2JBOD5

yes

86 SANRAD V-Switch User Manual